November 2014
3-4
Wear Pads
How to Replace the Scissor Arm
Wear Pads
Platform Scissor Arm Slider Blocks:
1 Remove the platform. See 2-1, How to Remove
the Platform.
2 Remove the slider blocks and discard.
3 Install the slider blocks.
Note: When installing the platform the drill holes in
the slider blocks must be on the top and bottom.
Top
Bottom
4 Install the platform.
Part No. 229753
GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 4 • Repair Procedures
Chassis Scissor Arm Wear Pads:
1 Attach a lifting strap from a suitable lifting
device to the ladder at the non-steer end of the
machine. Support the ladder. Do not apply lifting
pressure.
2 Remove the fasteners securing the ladder to the
chassis. Remove the ladder from the machine
and set aside.
Crushing hazard. The ladder could
fall if not properly supported when
the fasteners are removed from the
machine.
3 Using an overhead lifting device attach a strap
to the #1 inner arm at the non-steer end of the
machine.
Note: The overhead lifting device and strap must be
capable of supporting 5000 lbs / 2268 kg.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not properly
supported.
SCISSOR COMPONENTS
4 - 19