Perform Engine Maintenance - Perkins Models - Genie GS-2669 RT Service Manual

November 2014
13 Clean the inside of the hydraulic tank using a
mild solvent.
14 Install the drain plug using thread sealer on the
threads.
15 Install the suction strainer using thread sealer on
the threads.
16 Install the hydraulic tank onto the machine.
17 Secure the tank with the tank strap. Do not over
tighten.
18 Install the suction hose onto the tank.
19 Install the return filter and head assembly.
Note: Replace the return filter if needed.
20 Install the return hose to the return filter.
21 Fill the tank with hydraulic oil until the fluid is
within the top 2 inches / 5 cm of the sight
gauge. Do not overfill.
22 Clean up any oil that may have spilled. Properly
discard the oil.
23 Operate all machine functions through a full
cycle and check for leaks.
24 Check the oil level in the tank and add if
needed.
25 Install the tank cover plate and install the tank
cover plate mounting fasteners.
Part No. 229753 GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 3 • Scheduled Maintenance Procedures
CHECKLIST E PROCEDURES
E-2
Perform Engine Maintenance -
Perkins Models
Engine specifications require that this procedure be
performed every 2000 hours.
• Inspect alternator
• Replace crankcase breather
• Inspect engine mounts
• Inspect starter
Required maintenance procedures and additional
engine information is available in the
Perkins 403D-11 Operator's Manual
(Perkins part number SEBU8311-01).
Perkins 403D-11 Operator's Manual
Genie part number 131661
3 - 39