Steer Cylinder - Genie GS-2669 RT Service Manual

November 2014
How to Remove a Drive Motor
Component damage hazard.
Repairs to the motor should only
be performed by an authorized
dealer.
Component damage hazard. The
work area and surfaces where this
procedure will be performed must
be clean and free of debris that
could get into the hydraulic system
and cause severe component
damage. Dealer service is
recommended.
Note: When removing a hose assembly or fitting,
the O-ring on the fitting and/or hose must be
replaced and then torqued to specification during
installation. Refer to Section Two, Hydraulic Hose
and Fitting Torque Specifications .
1 Refer to Repair Procedure 11-1, How to Remove
the Yoke and Drive Motor.
2 Remove the drive motor mounting fasteners.
Remove the drive motor from the yoke.
Part No. 229753 GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 4 • Repair Procedures
STEER AXLE COMPONENTS
11-2

Steer Cylinder

How to Remove the
Steer Cylinder
Note: When removing a hose assembly or fitting,
the O-ring on the fitting and/or hose must be
replaced and then torqued to specification during
installation. Refer to Section 2, Hydraulic Hose and
Fitting Torque Specifications .
1 Tag, disconnect and plug the hydraulic hoses
from the steer cylinder. Cap the fittings on the
cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
2 Remove the rue ring from each cylinder clevis
pin. Remove the clevis pins.
3 Remove the steer cylinder from the machine.
4 - 71