Genie GS-2669 RT Service Manual page 111

November 2014
a
a ground control box
b level sensor
3 Tag and disconnect the wire harness from the
level sensor.
4 Remove the retaining fasteners securing the
level sensor to the compartment. Remove the
level sensor from the machine.
Part No. 229753
b
GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 4 • Repair Procedures
5 Install the new level sensor onto the machine
with the "Y" on the level sensor base towards
the steer end of the machine. Install and tighten
the level sensor retaining fasteners.
Tip-over hazard. The tilt level
sensor must be installed with the
"Y" on the level sensor base
towards the steer end of the
machine. Failure to install the tilt
level sensor as instructed will
cause the machine to tip over
resulting in death or serious injury.
d
Y
c X
a "Y" indicator
b level sensor
c "X" indicator
d chassis
GROUND CONTROLS
a
b
4 - 41