Genie GS-2669 RT Service Manual page 125

November 2014
16 Locate and remove the maximum height limit
switch from the lower slider channel and set
aside.
Note: Do not disconnect the limit switch harness.
a maximum height limit switch
Part No. 229753
a
GS-2669 RT • GS-3369 RT • GS-4069 RT
Section 4 • Repair Procedures
17 Locate and disconnect the lift cylinder pressure
switch harness.
Y7
a platform down solenoid valve
b lift cylinder
c pressure switch
18 On the machine side of the harness connect a
jumper from pin 1 (yellow) to pin 3 (red).
19 Pull out the red Emergency Stop button to the
on position and raise the platform approximately
10 feet / 3m.
20 Return the safety arm to the stowed position.
21 Lower the platform to the stowed position.
22 Place the maximum rated load in the platform.
Secure the load to the platform. Refer to
Section 2, Specifications .
23 Start the engine from the ground controls.
MANIFOLDS
AK
Y10
A I
a b c
4 - 55