Genie GS-2669 RT Service Manual page 157

November 2014
Error Source
ID Name
37 Auto Level Switch N/A
38 Oscillate
Limit Switches
39 Down Limit Switch 21
40 Oscillate Output
49 Drive Coil 1
Part No. 229753
Error Type
ID Name
Outrigger auto
level enable button
fault at platform
controls.
12 Value to high.
Voltage above
3000 mV.
15 Value to low.
Voltage below
1000 mV.
19 Voltage out of
range.
21 Voltage
inconsistent.
Voltage
inconsistent.
21 Both oscillate
valve outputs are
on at the same
time while
elevated.
Flashing or Motion
Beacon option is
set to on and it is
not installed on
the machine.
22 Oscillate valve
output is active for
more than 4 sec's.
N/A Drive coil 1 (Y27)
fault.
GS-2669 RT • GS-3369 RT • GS-4069 RT
Condition
Outriggers disabled.
Elevated drive and
platform up disabled. limit switches.
Elevated drive and
platform up disabled. limit switch.
Elevated drive and
platform up disabled. limit switches or
High speed drive
function disabled.
Section 5 • Fault Codes
FAULT CODE CHART
Solution
Troubleshoot button or
replace circuit board
at platform controls.
Troubleshoot oscillate
Troubleshoot stowed
Troubleshoot oscillate
replace ECU.
Set the option to off
if not installed on the
machine.
Troubleshoot 2 speed
valve coil.
5 - 5