Table of Contents
Advertisement
UK
Roller scraper
6.3 m
The scrapers are bolted on the end plates. In order to adjust the scraper bar loosen the 2 bolts at the
1
top
and push the scraper bar against the roller
placed 5 – 10 mm from the roller.
8.2 m
The scrapers are adjusted in the same way as for 6.3 m. In the
middle of the side sections 2 bolts are placed, which are to be
loosened too.
Maintenance
Lubrication
Important:
After every approx. 10 working hours all movable parts in the side sections are to be lubricated as
well as the 3 lubricating points on the wing cylinder. After every 30 working hours the tip cylinder's
pins and the 3 pins in the drawbar are to be lubricated.
The bearings of the roller are to be lubricated after every 100 working hours and/or after cleaning.
Important:
After the season, the roller is to be cleaned and lubricated with grease and oil.
Important:
Repairs
All repairs are to be performed with original HE-VA spare parts.
Grass-Roller 6.3m /8.2m
After every approx. 10 working hours
the wheels, ball bearings and stop rings
are tightened. Hoses, fittings and
cylinders are inspected for eventual
leaks and are tightened too.
Oil, type Hydro Texaco HD32 has been
filled in the hydraulic system.
The piston rods are to be lubricated with
grease, for long term storage.
2
. Please be aware that the scraper bar is to be
12
13/07-2018
2
1
Advertisement
Table of Contents
