ABB UMC100.3 Manual page 70

Custom application editor, universal motor controller

Hide thumbs Also See for UMC100.3:

Table of Contents

C U S T O M A P P L I C AT I O N E D I T O R M A N U A L

—

Function block reference

The functions blocks "AM1/2 Channel 1-3" should only be used in case of parameters "AM1 Mode" or "AM2

Mode" are set to "Universal". Otherwise the temperature function blocks "AM1/2 Temperature" shall be used.

Function Block

Outputs

Inputs

Parameters

Signal Name

AI/T: Analoge input value channel 1, 2 or 3

Wire break (only in configuration 4...20mA, value < 4mA)

Sensor Error: Temperature measurement is configured: short circuit or wire break detected

during temperature measurement

Out Of Range: Value is out of range

DO0: Set / reset the relay output on the VI15x module.

Enable: Enable FB calculation. Allows to disable function block execution in certain operation

states (e.g. startup ...)

HH/LL Trip: Triggers a channel related error message that the upper trip level / lower trip level

was reached. Message is signalled on the display and fieldbus

H/L Warn: Triggers a channel related warning message that the upper warn level / lower warn

level was reached. Message is signalled on the display and fieldbusus

AM1/2 Mode, AM1/2 Ch1/2/3 Error Reaction, AM1/2 CH1/2/3 Type

(0...65535)

Data Type

Word

Boolean

Table of Contents

Show Quick Links

Table of Contents