ABB UMC100.3 Manual page 48

48 C U S T O M A P P L I C AT I O N E D I T O R M A N U A L
—
Function block reference
—
Param To Bit
Normal parameters that can be set via fieldbus allow you to configure the predefined functions of the UMC.
There is one parameter byte which has no predefined function but can be used to adjust the function of its own function
block application. This can be used for example to enable or disable a part of the user-defined logic.
Function Block
Inputs
Output
Parameters
Signal Name
-
Bit 0 - Bit 7: Bits of the byte specified in the custom application parameter
The following parameter defines the output of the function block. For more information about the single
parameters see the UMC100 manual.
Custom App Parameter
Data Type
-
Boolean