ABB UMC100.3 Manual page 62

Custom application editor, universal motor controller

Hide thumbs Also See for UMC100.3:

Table of Contents

C U S T O M A P P L I C AT I O N E D I T O R M A N U A L

—

Function block reference

—

Softstarter

Use this function to control a softstater in one or two directions of rotation. Usually this control function is used together

with softstarters without own communication interface.

Function Block

Inputs (from top to bottom)

Outtput (from top to bottom)

Parameters

Signal Name

Rev: Run reverse signal, rising edge

Stop: Stop signal

For: Run forward signal, rising edge

DO3: Input to freely control DO3 if not used as fault output

Delay1: Delay for softstarter start output signal DO2

0...100 [0.1s], if input is >100 the value is set to 100

Delay2: Off-Delay for DO0 and DO1 after ramp down

0...100 [0.1s], if input is >100 the value is set to 100

Rev/Stop/For Status: Motor status

CB Fault: Checkback fault detected

Rev Lockout Time Running: Reversing lockout time is running

Ramp Up/Down Time Running: Ramping up, ramping down

Status DO0 ... DO3: Status of the outputs

See section "Control Function Softstarter" in the UMC100 manual.

Data Type

Boolean

Table of Contents

Show Quick Links

Table of Contents