ABB UMC100.3 Manual page 58

Custom application editor, universal motor controller

Hide thumbs Also See for UMC100.3:

Table of Contents

C U S T O M A P P L I C AT I O N E D I T O R M A N U A L

—

Function block reference

—

Star-Delta Starter

Use this function in a feeder that requires the motor to start in star-delta mode.

Function Block

Inputs (from top to bottom)

Output (from top to bottom)

Parameters

Signal Name

Stop: If logical 1 the motor will be stopped and cannot be started until the input changes

to logical 0 level.

For: Start motor

DO3: Output not used from the starter. Depending on the fault output configuration also

DO3 is controlled by the function block.

Stop Status: If the motor has been stopped this output is set to active 1

For Status (Forward): If the motor is running the output is set to active 1

CB Fault: A checkback fault has occurred.

YD Starting Time: This output is logical 1 in star mode and logical 0 in delta mode.

Start Time Run: During motor start this output is set to logical 1.

Status DO0 ... DI3: Mirror of the digital outputs of the UMC.

See section "Control Function Star-Delta Starter" in the UMC100 manual.

Data Type

Boolean

Table of Contents

Show Quick Links

Table of Contents