ABB UMC100.3 Manual page 55

C U S T O M A P P L I C AT I O N E D I T O R M A N U A L
—
Function block reference
—
Parameter to Process Value
With the help of the following function blocks it is possible to select which analog value is cyclically transmitted just by
setting parameters e.g. in the PROFIBUS GSD file. By default all five analog monitoring words are connected to these
function blocks. No programming is required anymore to change an analog value.
Function Block
Inputs
Output
Parameters
With the help of the following function block it is possible to dynamically change the transmitted analog value.
Function Block
Inputs
Output
Parameters
Signal Name
-
Out (W): The selected analog value
Param To PV 1... 5
Signal Name
In (W): The value selects one of the internally available analog values and makes it available on
the output. See UMC100.3 manual parameter "Param To PV1" to get a full mapping list.
Extract:
0 Current [%]
1 Thermal load [%]
2 Max Value (TTT and Time To Restart from FB Number of starts)
3 TTC
4 Scaled Active Power (scaled with power factor)
5 Max Motor Current At Startup [%]
6 Real Motor Startup Time
...
Out (W): The selected analog value
-
55
Data Type
-
Word
Data Type
Word
Word