Siemens SIMATIC IPC627E Operating Instructions Manual page 52

Installing and connecting the device
3.3 Connecting the device
Connecting several monitors (multi-monitoring)
You will find up to three ports on the rear of the device for connecting monitors. These ports
are connected to the motherboard.
Parameter assignment is performed by means of the Control Panel in Windows®.
The IPC is factory set for multi-monitoring. If needed, you can configure the multi-monitoring
function and the output of the boot screen in the firmware settings, see "Multi-monitoring
(Page 59) ".
The following table shows the various connection options for the monitors on the device
interfaces.
Monitor 1
Monitor 2
Monitor 3
1) - via DP to DVI-D adapter
2) - via DP-VGA adapter
52
Motherboard
DPP1
DP X
DVI X
VGA X
DP
DVI
VGA
DP
DVI
VGA
DPP2
-
-
1)
-
2)
- X
- X
1)
- X
2)
- -
- -
- -
Operating Instructions, 12/2018, A5E44297201-AA
DVI-D
-
-
-
-
-
-
-
X
-
SIMATIC IPC627E