Connecting The Power Supply; Connecting 100-240 Vac Power Supply - Siemens SIMATIC IPC627E Operating Instructions Manual

3.3.3

Connecting the power supply

3.3.3.1

Connecting 100-240 VAC power supply

Injury to persons or damage to property when operated on an incorrect power supply
system
If you connect the device to an unsuitable power supply, the device receives voltages and
currents that are too high or too low.
Injuries to persons, malfunctions or a damage to the device can result.
• The permissible rated voltage of the device must match the local supply voltage.
• Operate the device only in grounded power supply networks (TN networks in
• Operation in non-grounded or impedance-grounded networks is not permitted.
Safety regulations - connecting cable
Use only AC or DC connecting cables which comply with the local safety regulations.
Otherwise, there is a risk of fire and electric shock. This can result in personal injury or
property damage.
• Ensure that the AC or DC connecting cables comply with the safety regulations of the
• Connect the protective conductor in accordance with the operating instructions.
Risk of electric shock
The on/off button and on/off switch do not fully disconnect the device from the supply
voltage.
There is also a risk of fire if the device or connecting lines are damaged.
• Always fully disconnect the device from the supply voltage before performing work on
• For control cabinet mounting: Use a central, easily accessible AC circuit breaker close
• When you install the device, make sure that the power supply connector is easily
Note
The varying voltage power supply module is designed for operation on 120/230/240 V AC
networks. The setting of the voltage range takes place automatically.
SIMATIC IPC627E
Operating Instructions, 12/2018, A5E44297201-AA
WARNING
accordance with VDE 0100, Part 100 or IEC 60364-1).
WARNING
country in which the device is installed and bear the marks required in each case.
WARNING
the device or when the device will not be used over an extended period of time.
to the device, if possible.
accessible.
Installing and connecting the device
3.3 Connecting the device
47