Maxxus 6.2 Installation & Operating Manual page 14

Cockpit
CALORIES
WATT
Level Window
RPM Window
PACE Window
Profile Matrix
* Note on calorie measurement
Calculation of the energy consumption is done by means of a general formula. It is not possible to determine your individual energy consump-
tion exactly because this a large amount of personal data is needed. The energy consumption displayed is approximate, not exact value.
** Note on wattage
The watt display is not calibrated.
Buttons
RECOVERY
ENTER
START / STOP
Switch the device on
If the device is in standby mode (connected to power source with cockpit off) switch on either by starting ped-
alling or by pressing any button on the cockpit. Connecting the device to a power source using the AC adapter
automatically turns the cockpit on.
Switch the device off
The cockpit will automatically switch off approx. 4 minutes after pedalling stops, the exercise machine enters
standby mode. Please note, the device consumes minimal electricity on standby, therefore we recommend that
you always disconnect your exerciser from the mains when you are not using it.
Quick-Start Function
After the cockpit is switched on, press the START / STOP button. Training time starts to run automatically and
you can start training immediately. Training starts with the braking level pre-set to 9. You can enter the desired
braking level from 1 to 20 with the
ified with this programme, training must be stopped by the user.
Manual Training
Step 1: Programme Selection
Turn on the cockpit. Below the profile matrix "MANUAL" lights up. Press the ENTER button.
If "MANUAL" is not lit, but "PROGRAM", "WATT", "HRC" or "USER", press the
lit then press the ENTER button.
Window Displays calories used during the current training session from 0 to a maximum
999 calories *.
In the "Body Fat Measurement" programme the basal metabolic rate (BMR) is displayed
here.
Window Displays the current power output in Watts **.
Displays the current braking level from level 1 to 24
Displays the current pedalling speed / wheel revolution per minute.
In the "Body Fat Measurement" programme, body mass index (BMI) is displayed here.
Displays the required time per kilometre based on the current speed.
Graphical representation of the current programme history.
Button for measuring the recovery pulse
During exercise: buttons to increase or decrease the currently selected brake level
During programming: – Selection of programmes
– Specification of values
Key to confirm entries
START function: Pressing this button starts the selected workout.
If training was interrupted (paused) it can be re-started by
pressing this button again.
PAUSE function: Pressing this button while exercising pauses the current workout.
RESET function: In pause or stop mode, all values are reset to zero by pressing
and holding this key for more than 3 seconds.
buttons at any time during training. Since no target values can be spec-
14
buttons until "MANUAL" is