Mains Cable And Mains Adapter - Maxxus 6.2 Installation & Operating Manual

Mains Cable and Mains Adapter

Mains Cable
Insert the connector of the power cable supplied into the socket located on the rear of the main
housing. Then connect the mains cable to a power socket.
WARNNG
This device is only to be connected to an earthed socket installed by a qualified electrician. Do not
use a socket strip. If an extension cable is required, then it must comply with DIN standards, VDE
regulations and guidelines, technical rules issued by other European Union member states or other
states which are party to the Agreement on the European Economic Area.
Connecting the device
ACHTUNG:
Before connecting the mains adapter to the device, always check that it is the mains adapter sup-
plied with the device. Using a different mains adapter may damage the electronic components of the device, for which the
manufacturer assumes no liability.
Always connect the power cable to the exerciser before connecting it to a power outlet. If you want to disconnect your exer-
ciser from the power supply, always disconnect the power cable from the mains first.
Switch on the device
First connect the power cable to the exerciser and then connect the mains cable to the power socket, the cockpit turns on
automatically. If the training device is already connected to the mains, but the cockpit is in stand-by mode, activate the cock-
pit by pressing any key or by moving the pedals.
Turn off the device
When inactive for more than 4 minutes, the cockpit automatically switches to stand-by mode. Once you have finished your
workout you should always disconnect the exerciser from the mains. Always unplug the mains cable from the wall socket
first and then remove the power cable.
Transport
In order to transport your training device simply and safely, the front stand is equipped with transport rollers. To move the
exerciser, stand in front of the handlebars and grab them with both hands. Pull the training device gently towards you and
lower the handlebars until the rear stand no longer has contact with the ground and the main weight of the exerciser is rest- ENG
ing on the transport rollers. Now you can simply pull the exercise machine along on the transport rollers and into the desired
position. When lifting, transporting and positioning the device always make sure that you have a secure footing.
Bike similar to this figure
Transport wheels
Location and Storage
This training device was designed for exclusive use in dry, well-ventilated indoor areas. The use or storage in damp or wet
areas, such as saunas, swimming pools, etc. and in outdoor areas, such as balconies, terraces, gardens, garages, etc. is
excluded.
These locations may give rise to electronic defects, corrosion and rust due to the high humidity and low temperatures pre-
vailing there. Under no circumstances will any claims for damages of this kind be accepted under the warranty.
Please choose a dry, level and warm place to store your training device. For your own sake, also make sure that you
choose a training area which is sufficiently ventilated to ensure optimum oxygenation during training.
Before putting your training device back into operation after a long period of non-use, make sure that all fastenings are
secure.
11