Cockpit; Eng; Maintenance & Care - Maxxus 6.2 Installation & Operating Manual

WARNING
Before starting cleaning, maintenance and / or repair work, the exerciser must be completely discon-
nected from the power supply. This will only be the case if the power cable is disconnected from the
power outlet and the exerciser. Therefore, first disconnect the power plug from the power outlet, and
then disconnect the power cable from the exerciser. The mains cable may only be reconnected to the
training device and the power supply when all work has been completed and the proper training condi-
tion of the device has been restored.
Cleaning
Clean your exerciser after each workout. Use a damp cloth and soap.
Never use solvents.
Regular cleaning contributes significantly to the preservation and longevity of your training device.
Damage caused by sweat or other liquids is not covered by the warranty under any circumstances. During train-
ing, make sure that no fluid can enter the exercise machine or the computer.
Maintenance
Sealed bearings are used in your training device, lubrication of the bearings is not required.
Checking the fastenings
Check tightness of nuts and bolts at least once a month and re-tighten them if necessary
Checking the components
Before each workout, check that the saddle, seat support, handlebars and pedals are securely fastened.
WARNING:
Never train if one or more of these components are loose.
Displays the following training values:
TIME Window Displays current completed training time from 0:00 to a maximum 99:59 minutes.
SPEED Window Displays current speed in km / h.
In the "Body Fat Measurement" programme the body fat percentage is displayed here.
DISTANCE Window Displays the current training distance from 0.0 to a maximum 99.99 kilometres.
PULSE Window Displays the current pulse rate when using the hand pulse sensors.
Displays the current heart rate when using a transmitter chest belt (not included).
13
Maintenance & Care

Cockpit

ENG