Installation & Standby Circuit - Powtran PI7500 Series User Manual

Section I. Inspection and Safety Precautions
lead danger (e.g. lift tools of transportation, aviation system, saftety
equipment, etc), it should be managed carefully. Do inquire the factory
when it happens.
Only the well-trained personnel are allowed to use
this unit, and such personnel must read through the
parts of this manual relating to the safety, installation,
operation and maintenance before using the unit. The
safe operation of this unit depends on correct
transport, installation, operation and maintenance!
3
Section II. Installation & Standby Circuit
2-1. Conditions for Use
1) Ambient temperature -10℃~40℃.
2) Avoid electromagnetic interference and keep the unit away from the
interference source.
3) Prevent dropping water, steam, dust, powder, cotton fiber or fine metal
powder from entering it.
4) Prevent oil, salt and corrosive gas from entering it.
5) Avoid vibration.
6) Avoid high temperature and moisture and avoid being wetted due to
raining, with the humidity below 90%RH (not dewing).
7) Prohibit the use in the dangerous environment where inflammable or
combustible or explosive gas, liquid or solid exists.
2-2. Installation
The frequency inverter must be installed by wall hooking in the indoor room
with adequate ventilation, with enough space left between it and the
adjacent objects or damper (walls) surrounding it, as shown in the below
figure:
+ -
50MM
50MM
P RG FWD
SET R EV
E SC ST OP
DI SP L JOG R ESET
4