press
up LED
▲ key
down LED
glitter
glitter
press
▲ key
twice
press SET key
to affirm
e.g. 2 Modify o15=0 to o15=1
With F00, press ▼ selecting F69.
1.
2.
Press PRG entering I/O group parameters menu.
Press ▼ selecting o15.
3.
4.
Press PRG once modifying o15.
5. Press ▲ once, upper LED flashes "1".
6. Press SET confirming value modification.
press
up LED
▼ key
down LED
glitter
press
▲ key
once
press SET key
to affirm
Section III. Operating keyboard
glitter
press
PRG key
once
press PRG key
once
glitter
press
PRG key
once
press
PRG key
once
press ▼ key
glitter
press
PRG key
once
17
Section IV. Test running
●
Before connecting the power supply with the frequency converter,
confirm that the input voltage of AC power is within the rated input
voltage of the frequency converter.
●
Connect the power supply with the R, S and T terminals of frequency
converter (connect with R and S terminals for single-phase input).
●
Select the proper operation control method.
e.g.: analog voltage input + keyboard /terminal operating (Pr.F04=1,
Pr.F05=1).
The frequency command is controlled by terminal V2, and the operation is
controlled by the keyboard and terminal FWD、REV.
e.g.: keyboard adjust speed + keyboard operating (Pr.F04=0, Pr.F05=0)
The frequency command is controlled by the key , and operation is
controlled by the key FWD、REV controlling the forward and reverse.
℃
%
S
F WD
RE V
AL A RM
H
Z
A
V
DIGIT AL O PE RATOR
RUN
STO P
RES ET
PRG
ESC
SET
DISPL
J P -1 0
18