Powtran PI7500 Series User Manual page 23

setting
frequency
output
frequency
braking
frequency
forward
FOR
reverse
command
stop braking (forward and reverse rotate)
setting
frequency
braking
frequency
output
frequency
braking
frequency
stop braking time
RUN
ON
STOP
stop braking (run state)
output
frequency
start up braking
RUN
ON
STOP
start up braking
F27: Stop mode set
When receiving "stop" command, it sets the stop mode according to this
parameter.
0: Deceleration stop mode, according to the deceleration time set by this
parameter, inverter decelerates to the lowest frequency and stops.
1: Free stop mode. "Stop" command to the inverter, it stops output, motor
runs free until stops due to the effects of load inertia.
Section VI. Function Parameter Description
time
stop braking time
time
setting
frequency
REV
time
time
time
factory setting: 0
41
Section VI. Function Parameter Description
F28: Jog acceleration time
F29: Jog deceleration time
Jog acceleration time defines the same step acceleration/deceleration.
Max frequency
JOG frequency
0
f28
Actual jog time equals to the set acc/dec time multiples a time multiple
which is decided by the tens digit of F56. Please refer to F56.
F30: Jog direction set
0: Forward
1: Reverse
F31: Jog frequency set
Jog frequency setting range is from lower limit frequency to upper limit
frequency.
F32: Traverse running frequency f1
F33: Traverse running frequency f2
F34: Traverse running difference △f
F35: Traverse running timing T1
F36: Traverse running timing T2
Calculating acceleration/deceleration time with f1、f2、△f、T1、T2.
output frequency
traverse f1
traverse f2
accelerate
T1
running
instruction
F37: Skip frequency 1
F38: Skip frequency 2
factory setting: 1.0s
factory setting: 1.0s
time
f29
factory setting: 0
factory setting: 6.00/60.0Hz
factory setting: 40.00/400.0Hz
factory setting: 20.00/200.0Hz
factory setting: 2.00/20.0Hz
factory setting: 2.0s
factory setting: 2.0s
f f f
f f
f
decelerate
T2 T1 T2 T1
time
time
factory setting: 0.00/0.0Hz
factory setting: 0.00/0.0Hz
42