Powtran PI7500 Series User Manual page 10

Positive/Negative
Value indication light
+ -
Speed Status light
* Display of running status
Off:Stop status
SPEED-STATUS
Flash:Acc/dec status
On:Even Speed status
Paramiter
setting/shift key
DIGITAL OPERATOR
Parameter Alternation
PRG
Key (acc/reduction key)
SET
Acc. selection/
Parameter setting
ESC
Escape/Display
DISPL
Jog key
function description
Forward key:
Drive forward.
◇
Reverse key:
◇ Drive reverse.
Stop/Reset key:
◇ Drive stops, resets after abnormity and confirms fault.
Acc. Selection /Parameter setting:
◇ When select parameter, press the SET key and add/reduction key, parameter code
add/reduce 10
◇ Restore modified value
alternate the monitor object and monitor
◇
Escape/display
Escape modifying the data of function parameters
◇
Escape of submenu or running into menu of status display from function menu
◇
Escape of fault status.
◇
Jog key
On: jog
◇
Section III. Operating keyboard
Alarm Indication Light
ALARM
LED main display area
FWS/REV Indication light
FWD REV
LED main display area
Forward command light
Forward key
FWD
Reverse command light
REV
Reverse key
STOP
JOG
RESET Stop/Reset key
JP-07
15
Section III. Operating keyboard
◇ Off: stop
The upper LED main display area
Display frequency, current, voltage, etc. Also display fault code, password right
◇
FWD/REV Indication light
◇ Display motor's running state: forward or reverse.
The nether LED main display area
◇ Display function code
Display set frequency during running
◇
JP6E7000 is standard keyboard for PI7000, PI7100 Family inverter.
JP6C7000 keyboard has the same structure and instruction with those
of JP6E7000. The difference is that the lower LED display is changed into
LCD display which displays the state and parameters in English. JP6C7000
is the optional keyboard for PI7000, PI7100. The following diagram is the
description to JP6C7000 LCD display:
The second
monitor select
F65=4 output voltage
200
9 PID set Value ％
●
For the 4 keypads, when the keypad is unlocked, press the
simultaneously for 3 seconds, the keypad is locked, LED displays
normally after displaying "LoC" for 2 seconds; when the keypad is
locked, press the and
keypad is unlocked, LED displays normally after displaying "ULoC" for
2 seconds.
3-4 Parameters set mode
e.g. 1 Modify acceleration time F09=5.0 to F09=25.0:
1. With F00 mode, press ▲ selecting F09, upper LED displays 5.0.
2. Press PRG for 3 times, upper LED ten digits "0" flashes.
3. Press ▲ for twice, upper LED ten digits displays "2".
4. Press SET confirming value modification.
The third
monitor select
F66=2 motor actual current
16.0
LCD main display area
simultaneously for 3 seconds, the
16
and