Powtran PI7500 Series User Manual page 29

>10ms
SS1
SS2
>10ms
SS3
output frequency
H09
H07
set frequency
H18 H14
H19
*7: Reserved
F64: Selection of input terminal's polarity
7 6 5 4 3 2 1 0
2 2 2 2 2 2 2 2
7 6 5 4 3 2 1 0
SS1
JOG
FWD
REV
SS2
SS3
FRE
RST
Set Polarity of Input Terminal
Low level valid(close)
0
Falling edge valid, rising edge invalid
High level valid(open)
1
Rising edge valid, falling edge invalid
7 6 5 4 3 2 1 0
2 2 2 2 2 2 2 2
1 1 0 0 0 0 1 1
SS1
F64 =bit7*2
JOG
FWD
REV
SS2
SS3
FRE
RST
Section VI. Function Parameter Description
>10ms
>10ms >10ms
>10ms
H08
H08 H07 H09
H17 H14 H19
H16
H15
factory setting: 0
Low level valid(close)
Falling edge valid, rising edge invalid
High level valid(open)
Rising edge valid, falling edge invalid
7 6 1
+bit6*2 +......+bit1*2 +bit0*2
7 6 5 4 3 2
=1*2 +1*2 +0*2 +0*2 +0*2 +0*2
1 0
1*2 +1*2
=128+64+2+1
=195
53
Section VI. Function Parameter Description
F65: Monitor selection 2
Monitor the second objects, range from 0~15 (same as F00), valid when
using keyboards JP6E7000 and JP6C7000. Please refer to the keyboard
operation in the section III.
time
F66: Monitor selection 3
F65, F66 respectively select the first monitored object and the second
monitored object which range from 0~15(the same as F00 monitored
time
objects). They are valid when it is operated by JP6E7000 and JP6C7000.
Refer to the section III: Operating keyboard.
F67: V/F curve set
time
F68: MSS speed control
F69: I/O group select
F70: CUR group select
time
F71: SPD group select
F72: PID group select
F73: SYS group select
F74: MOT group select
Selecting one of these above groups as expected, press PRG running into
the relative group.
6-2. Other parameters
6-2-1. F67 V/F curve set [V/F]
U00: V/F set frequency 1
User set the first frequency of V/F curve corresponding with V1.
U01: V/F set voltage 1
User set the first voltage percentage of V/F curve corresponding with F1, by
the reference of inverter's rated output voltage 100%.
U02: V/F set frequency 2
User set the second frequency of V/F curve corresponding with V2.
U03: V/F set voltage 2
User set the second voltage percentage of V/F curve corresponding with F2,
by the reference of inverter's rated output voltage 100%.
0
U04: V/F set frequency 3
+ User set the third frequency of V/F curve corresponding with V3.
factory setting: 1
factory setting: 2
factory setting: 5.00/50.0Hz
factory setting: 5%
factory setting: 10.00/100.0Hz
factory setting: 10%
factory setting: 15.00/150.0Hz
54