NTN-SNR LINEAR AXIS AXC Series Manual page 41

Guiding system of the Linear Axis from the series AXC and AXDL with Track roller guides (Guiding system L und M)
For Linear Axis of the AXC series in tilted position, the lubrication amount increases by a factor specified in Table 4.4. In the overhead
position, this factor is to be applied only for the first re-lubrication.
For Linear Axis of the AXDL series, the factor is only to be applied for the first re-lubrication in tilted and overhead position.
Table 4.4 ____ Lubrication amount of the track roller guides (Lubrication points without marking or with marking „F")
Type
AXC40
AXC60
AXC80
AXC100
AXC120
AXDL110
AXDL160
AXDL240
Guiding system of the Linear Axis from the series AXF with polymer track roller guide (Guiding system P)
The guiding system of this Linear Axis is maintenance free.
Guiding system and ball screw drive of the Linear Axis from the series AXBG
For Linear Axis of the AXBG series, the lubrication of the guiding system is supplied via grease nipples. The lubrication is to be carried
out on each carriage.
For re-lubrication of the ball screw drive the lubricant must be applied directly onto the screw drive over the entire length.
Table 4.5 ____ Lubrication amount of the Linear Axis AXBG
Type
A
AXBG15 0,5
AXBG20 0,5
AXBG26 1,0
AXBG33 2,0
AXBG46 5,0
AXBG55 7,0
Factor
3
5
2
3
3
AXDL
3
4
5
Lubrication amount per lubrication point [cm³]
B C
AXBG
0,5
0,5
1,0
2,0 1,5
5,0 3,5
7,0
Lubrication amount per lubrication point [cm³]
L
AXC
0.4
0,4
2,0
2,0
2,0
1,0
1,5
2,8
D
1,5
3,5
39
M
0.4
0,4
2,0
2,0
2,0
1,0
1,5
2,8
Lubrication amount ball screw
[cm³/100mm]
0,5
0,5
1,0
2,0
3,0
4,0