Drive Options - NTN-SNR LINEAR AXIS AXC Series Manual

6.2

Drive options

6.2.1 Plug-in shaft
Plug-in shafts are common variants of the form-fitting drive
adaption (Figure 6.23), which is available for Linear Axis of the
AXC_Z, AXC_A, AXDL_Z and AXDL_A series.
For optimal alignment of the fastening elements for the drive,
it is necessary to specify the mounting side for the machining
of the profile. The delivery includes the corresponding sliding
blocks for the drive fixing. The dimensions are shown in Figure
6.24 and Table 6.15. For applications with higher dynamics,
we recommend force and form-fitting drive adaptations with
integrated couplings as described in chapter 6.2.2 or 6.2.4.
1 sliding block / Threaded hole
2 machined mounting surface for
the drive adaption
The dimensions of the plug-in shafts are shown in Figure 6.24 and Table 6.15
Figure 6.24 __ Dimensions plug-in shaft and mounting dimensions
Table 6.15 ___ Dimensions plug-in shaft
Type a b
[mm] [mm]
AXC40Z
23 26H7x1
AXC40A
AXC60Z
34 47H7x1
AXC60A
AXC80Z
42 68H7x2
AXC80A
AXC100Z 53 90H8x2
AXC120Z 61 102H8x2
61 102H8x2
AXC120A
(Ø162) 2 (110H8x3,5)
AXDL110Z 60H8x19
AXDL160Z 75H8x41
AXDL160A 80H8x3
AXDL240Z 90H8x53
AXDL240A 110H8x3,5
1 - Not applicable for drive adaption WD
2 - Dimension of the machined surface from the opposite side
c 1 d h6 d2
[mm] [mm]
1 10 M4x7
1 14 M5x8
2 20 M6x10
25 M10x17
2 30 M10x17
2 30 M10x17
2
16 M5x8
25 M10x17
-- --
30 M10x17
30 M10x17
178
Figure 6.23 __ Plug-in shaft
e f g
[mm] [mm] [mm]
34,0 9,90 8,10
54,0 22,50 17,50
72,0 23,00 20,50
85,0 42,50 42,50
104,0 42,50 42,50
104 42,50 42,50
(91,9) 2 (45,95) 2 (45,95)
48,1 24,05 24,05
66,0 25,00 25,00
70,7 35,35 35,35
70,7 35,35 35,35
91,9 45,95 45,95
i l s
[mm] [mm]
29,5 30 M3x5
30,0 30 M5x6
39,3 40 M5x9
53,5 50 M8x12
59,5 60 M8x12
M8x12
59,5 60
2 (M8x13)
55,5 30 M5x10
92,3 50 M6x15
-- -- M6x12
113,5 60 M6x18
113,5 60 M8x15,5
2