Drive Assembly On Linear Axis And Linear Tables With Screw Drive - NTN-SNR LINEAR AXIS AXC Series Manual

3.7.3

Drive assembly on Linear Axis and Linear Tables with screw drive

The assembling of drives on Linear Axis and Linear Tables with screw drive and coupling cone is carried out according to the following
steps (Figure 3.13):
1. Insert the coupling hub
and dimension B when using an optional intermediante flange
2. Tighten the clamping screw
3. Insert elastomeric gear rim
drilled through. A shorter feather key for excchange is delivered as well.
4. Insert the drive with the coupling hub
on the drive or gearbox shaft. The dimension A (Figure 3.14) from Table 6.24 in Chapter 6.2.4.2
2
with the required tightening torque according to Chapter 3.5 Table 3.3.
3
. For drives with feather key and shaft diameter 19 and 24 mm the elastomeric gear rim is
4
in the coupling hub from the Linear Axis and screw it with the coupling cone
2
Figure 3.13 __ Drive assembly on Linear Axis with screw drive
Figure 3.14 __ Mounting dimension
, should be considered.
5
29
.
1