Cable Guiding - NTN-SNR LINEAR AXIS AXC Series Manual

6.3.2

Cable guiding

The cable of the inductive proximity switches for the AXC series are laid in a groove to the drive. The cable length is chosen such that
at least 0.5 m free cable length remains. If this is not possible with the maximum available cable length, the cable is led out on the
opposite side. Only two inductive proximity switches per side can be used for the type AXC60.
The cable of the inductive proximity switches I2 are laid in a groove to the drive except for AXC40. The cable length is chosen such
that at least 0.5 m free cable length remains. If this is not possible with the maximum available cable length, the cable is led out on the
opposite side. For the type AXDL 110 Z the cables are always laid out to the deflection pulley side. For the type AXLT155 the cables
are always laid out to the drive side.
6.3.3 Mounting options
Depending on series and size a variety combination and assembly options of limit switches are possible, which are summarized in
Table 6.31. The most common combinations can be encoded on the type code.
An overview of these options contains Table 6.36 in Chapters 6.3.7.
Table 6.31 __ Switch mounting on NTN-SNR – Linear Axis
Inductive proximity switches (I1)
AXC40Z
AXC40S
AXC40T
Inductive proximity switches (AXC Initiator)
AXC60Z
AXC60S
AXC60T
1
AXC – Initiator
2
Cable guide
Inductive proximity switches (AXC Initiator)
AXC80Z
AXC80S
AXC80T
AXC100Z_B
AXC100Z_C
AXC100Z_L
1
AXC – Initiator
2
Cable guide
AXC
l1
1 2
1 2
195
Mechanical (M2,M3) and inductive proximity switches (I2)
M2 l2
Mechanical (M1) and inductive proximity switches (I2)
M1 l2
M3