Mounting Instruction - NTN-SNR LINEAR AXIS AXC Series Manual

3.3

Mounting instruction

When mounting the Linear Axis (incomplete machine) listed below conditions must be fulfilled so that they can be assembled correctly
and without affecting the health and safety of staff with other parts to form a complete machine.
Caution! The motor housing can reach high temperatures during operation.
The Linear Axis should be installed so that the structure-borne
noise is minimized. Other machine parts should be designed so
that they do not lie in the resonance range of the Linear Axis.
NTN-SNR Linear Axis of the AXC and AXDL series can be fastened
by sliding blocks or mounting strips at plane surfaces or other
Linear Axis from the NTN-SNR product range. The number of
mounting points must be matched to the application. With punctual
support of the Linear Axis, the resulting bending does not impair
the function nor impair the required accuracy. The mounting
strips are laterally hooked on the Linear Axis profile and, thanks
to its special design are easy to assemble by screwing them from
above (Figure 3.3).
They can be positioned anywhere within the entire profile length.
Alternatively, all Linear Axis can also be mounted on swivel-sliding
blocks, which can also be freely positioned along the entire length
(Figure 3.4).
For Linear Axis of the AXLT and AXLM series are also two mounting
options available, either through a direct screw from the top or
by swivel-sliding blocks for the grooves on the underside of the
base plate.
The sliding blocks can be freely positioned along the entire length
(Figure 3.5).
Figure 3.3 ___ Fastening strips AXC / AXDL
Figure 3.4 ___ Sliding blocks AXC / AXDL
Figure 3.5 ___ Sliding blocks AXLT / AXLM
24