Pepperl+Fuchs VBG-ENXK20-DMD-EV Manual page 64

AS-i 3.0 EtherNet/IP+Modbus TCP Gateway
The Modbus Address Table
Data_Exchange_Active: If this output is set, no data transmisson between the
Auto_Address_Enable: This output blocks the automatic slave-address program-
Configuration_Mode_on: Configuration mode is on
Configuration_Mode_off: Configuration mode is off
Auto_Address_Assign: Automatic programming is allowed
Auto_Address_Available: Automatic programming is possible
Configuration_Active: The configuration-mode is active
Normal_Operation_Active: The normal operation mode is active
Duplicate Address: AS-i duplicate address detection
64
AS-i/Gateway and the AS-i slaves is possible.
0: Data exchange is active
1: Data exchange is not active
Off-line: This output sets the master into the off-line phase
ming.
0: Auto-address is enabled
1: Auto-address is disabled
Config_OK: Configuration error:
0: no error
1: error
LDS.0: An AS-i slave with address zero exists
0: Auto-address is possible
1: Auto-address is not possible
0: normal operation is active
1: normal operation is not active
APF/not APO: An AS-i power fail occured
Offline_Ready: The off-line phase is active
Periphery_OK: Periphery is OK
0: Periphery is OK
1: Periphery is not OK
Earth Fault: AS-i earth fault detection
0: no earth fault
1: earth fault
Overvoltage: AS-i overvoltage detection
0: no overvoltage
1: overvoltage fault
Noise: AS-i noise detection
0: no noise
1: noise fault
0: no duplicate address
1: duplicate address