Omron SYSMAC CS Series Operation Manual page 44

CX-Profibus Configurator
Item
Device setup
Master setup
Bus parameter setup
Slave area setup
Monitoring functions
Additional Master functions
Support functions
Bus parameter setup
Address mapping setup
Monitoring functions
Support functions
Support functions
I/O configuration setup
Parameter setup
Group setting
Monitoring functions
Support functions
Device setup allows the user to:
• Select the PROFIBUS Master Unit's unit number.
• Configure the communication link between the PC and the Unit. This
function invokes the user interface of CX-Server.
• Test the Units communication link and read out the Unit's information.
It allows enabling of Auto Addressing, to facilitate I/O data mapping, as
well as defining the Unit's behaviour in case of
• a network malfunction.
• PLC mode changes between PROGRAM and RUN/MONITOR mode.
The bus parameter setup allows the selection of baud rate and calcula-
tion and editing of specific bus parameters.
The Slave area setup allows the user to define the I/O Data mapping of
the I/O Data from each of the slave devices on to PLC memory areas.
• Master status read out.
• Slave status and slave diagnostics read-out.
• Read out of the Unit's error log.
• Set remote slave address.
• Communication channels for PROFIBUS DP-V1 MSAC1 messages.
• Communication channels for PROFIBUS DP-V1 MSAC2 messages.
Note These functions are implemented as of Unit version 3.0.
• Context sensitive help functions.
• Multi-language support.
The bus parameter setup allows the selection of baud rate and calcula-
tion and editing of specific bus parameters.
The address mapping setup shows an overview of the mapping of the
I/O data of each Slave on to the Unit's memory. The mapping can be
accomplished automatically, but the function also allows editing of indi-
vidual address mappings.
• Master status read out.
• Slave status read-out.
• Context sensitive help functions.
• Multi-language support.
• Context sensitive help functions.
• Multi-language support.
The I/O configuration setup function allows:
• Selection of device address.
• Enable/disable watchdog.
• Overview of available I/O modules.
• Selection of I/O modules, including Addition, Insertion and Removal of
multiple modules.
The Parameter setup function:
• Setting of common as well as module dependent parameters.
• Setting of PROFIBUS DP Extension parameters.
• Setting of PROFIBUS DP-V1 dependent parameters.
The Group setup function allows definition of the group to which the
associated slave device will belong.
The Monitoring functions provides a display of
• Standard Slave diagnostics flags.
• Extended diagnostics messages.
• Context sensitive help functions.
• Multi-language support.
Note For more information on the GRT1-PRT DTM, refer to the SmartSlice GRT1-
series GRT1-PRT PROFIBUS Communication Unit Operation Manual
(W04E-EN-@).
Specification
Section 1-4
23