Configurator Error And Warning Messages - Omron SYSMAC CS Series Operation Manual

Configurator Error and Warning Messages

D-1 Warning Messages
The table below lists the Warning messages which can be displayed by the PROFIBUS Master Unit DTM.
These messages usually indicate that the user is about to perform an action, which will have significant impact,
or an action which is only partly supported by the Unit. The user is given a chance to abort the function if the
impact is undesirable.
Number Message
00 Change the PLC to PROGRAM
mode?
01 PROFIBUS DP-V1 Slave/slaves is
assigned to master. PROFIBUS
DP-V1 slaves are not fully sup-
ported.
02 Return the PLC to [mode] mode?
03 PLC Memory "area overlapping"
and/or "exceeding memory range"
Save anyway?
04 Settings have been changed.
Would you like to save?
05 Settings have been changed.
Would you like to leave without
saving?
06 Compressing will re-allocate slave
configuration in [memory area].
Continue?
Note [Memory Area] = Input
Area 1/ Input Area 2/ Out-
put Area 1/ Output Area 2
Appendix D
Description
In order to start downloading a configuration, the
PLC must be set to PROGRAM mode, to prevent
I/O data being exchanged with the Unit, during
the change of the configuration.
• Yes Change state and download configura-
tion.
• No Stop download.
The PROFIBUS Master Unit supports only basic
DPV0 functions. This means that the PROFIBUS
DP-V1 slave can still be operated, but the
PROFIBUS DP-V1 functionality is not possible:
• OK Close message box.
After download with PLC previously in RUN or
MONITOR the PLC can be returned to RUN or
MONITOR mode
• Yes Change state.
• No PLC remains in PROGRAM mode.
• Cancel PLC remains in PROGRAM mode.
One or more of the PLC Memory mappings is
incorrect. The I/O data, a part of the I/O data or
the PROFIBUS DP-V1 Status Monitoring table is
mapped beyond an existing memory area, or two
or more mappings are overlapping in memory.
• Yes Save settings.
• No Do not save settings.
• Cancel Do not save settings.
One or more settings have been changed, but
not yet saved.
• Yes Save data and close DTM.
• No Do not save data and close DTM.
• Cancel Do not close the DTM.
Closing the GUI without saving the configuration.
• Yes Do not save data and close DTM.
• No Do not save data and do not close
DTM.
Each of the slave I/O data mapping areas can be
compressed, by pressing the Compress button.
This will result in the DTM filling up all the gaps in
the mapping, by moving I/O data from higher
addresses closer to the start address of the map-
ping area.
• Yes Compress memory area.
• No Do nothing.
When occurring
At the start of download-
ing, in case the PLC is in
RUN/MONITOR mode.
At the start of download-
ing, in case one of the
slaves is a PROFIBUS
DP-V1 slave.
After completing the
download.
Closing the Configura-
tion User Interface with
invalid configuration or
saving invalid settings
Closing the Configura-
tion User Interface with-
out saving the changes.
Closing the Configura-
tion User Interface with-
out saving the changes.
When pressing the
Compress button in the
Slave Area tab, I/O Allo-
cation.
247