Omron SYSMAC CS Series Operation Manual page 121

Generic Slave Device DTM
Group Tab
Selecting the Groups
Extensions Tab
100
In the Group tab the user can define to which group the slave device will
belong. This group definition is used to define multi-cast groups of slave
device to which a Global-Control message can be transmitted. The window is
shown below.
The user can check the check boxes for each group the slave device will
belong to. The group setting is transferred to the slave device as part of the
parameter message.
The three tabs discussed above, allow for making all the standard PROFIBUS
DP settings for a slave device. For slave devices supporting PROFIBUS DP-
V1, two additional tabs will show up. These tabs will appear, if the GSD file
parameter GSD_Revision is set to 3 or higher. The additional tabs are dis-
cussed below.
The Extensions tab contains a number of settings, which define additional
behaviour of the CS1/CJ1W-PRM21 PROFIBUS Master Unit with respect to a
particular PROFIBUS DP-V1 slave device. Although this specific behaviour is
defined in the PROFIBUS DP extensions standard (PROFIBUS DP-V1) it
does not necessarily require PROFIBUS DP-V1 capabilities from the PROFI-
BUS Master Units. The Extension tab is shown below.
Section 3-5