Quitting The Debugger - Epson S5U1C17001C Manual

8.3.4

Quitting the Debugger

 Command operation 
Debugging is terminated using the quit command input.
(gdb)quit
 IDE operation

Debugging can be terminated using any of the methods below.
The [Debug] view display will change to the terminated state after debugging has ended.
 Select [Terminate] on the [Run] menu
 Click the [Terminate] button in [Debug] view.
 Click the [Terminate] button in [Console] view.
 Select [Terminate] from the Context menu in [Debug] view.
Note: When using an ICDmini to debug a program, always be sure to close the debugger before turning off
power to the ICDmini. Should you turn off power to the ICDmini while running the debugger, you will be
unable to reconnect it.
S5U1C17001C Manual
(Rev. 1.0)
Seiko Epson Corporation
8 Debugger
8-6