Configuring Network Settings; Tcp/Ip; Figure 5-9 Tcp/Ip Interface; Table 5-7 Tci/Ip Configuration - Honeywell Performance HED1PR3 Software Configuration Manual

58 | Performance Series IP Camera Software Configuration Guide

Configuring Network Settings

TCP/IP

www.honeywell.com/security
Figure 5-9 TCP/IP Interface
Table 5-7 TCI/IP Configuration
Parameter Function
Configure to set the current host camera's name. Maximum 32
Host Name
characters.
Select an Ethernet port. The default is wire LAN.
Ethernet Card
Note
Select Static or DHCP mode.
The IP Address, Subnet mask, and Default Gateway are greyed out
when you select DHCP mode to automatically search for the IP
address.
If Static mode is selected, you must manually assign the IP
Mode
Address, Subnet mask, and Default Gateway.
If DHCP mode is selected, the IP Address, Subnet mask, and
Default Gateway are assigned automatically.
Note
MAC Address Displays the MAC address.
If you modify these settings, you will have to reboot your
camera to activate the new setup.
IP Address, Subnet mask, Default Gateway, and DHCP
are read-only when PPPoE is enabled.