Parameter Assignment; Overview Of Parameters And Functions - Siemens SITRANS Series Operating Instructions Manual

Parameter assignment

9.1

Overview of parameters and functions

Introduction
You can operate the device via local operation or remote operation (e.g. HART communicator,
SIMATIC PDM).
● The parameters that you can reach over the device with a display are marked by the
parameter ID. Hereinafter, the parameter ID is always written inside parentheses after the
parameter name. Example: Parameter "Damping value" [04].
● You can access the complete number of parameters via remote operation.
The device-specific parameters are available in each tool for configuration.
The instructions or online help for these tools will provide you with information on how to
use the different tools for parameter assignment.
List of parameters and functions
The following parameters are available via the local operation and via remote operation (e.g.
SIMATIC PDM).
The parameters are grouped according to their function in the following overview:
Quick start
Quick start wizard
Current output
Apply lower range value (with pressure applied)
Apply upper range value (with pressure applied)
Set lower range value (without pressure applied)
Set upper range value (without pressure applied)
Set damping value
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA
SIMATIC PDM Device with display
Menu command "De‐ -
vice > Wizard - Quick
start..."
SIMATIC PDM Device with display (lo‐
cal operation)
Menu command "De‐ Apply lower range val‐
vice > Apply values" ue parameter [08]
(Page 118)
Apply upper range val‐
ue parameter [09]
(Page 118)
"Settings > Current out‐ Set lower range value
put" parameter group parameter [02]
(Page 104)
Set upper range value
parameter [03]
(Page 104)
"Settings > Current out‐ Damping value [04]
put" parameter group (Page 105)
9
Device without display
-
Device without display
(local operation)
Commissioning the de‐
vice without display
(Page 13)
-
-
97