Rotating The Enclosure - Siemens SITRANS Series Operating Instructions Manual

5.7

Rotating the enclosure

Introduction
To make the device easier to operate in any mounting position, you have the option of adjusting
the position of the enclosure within a range of 360°.
①
One retaining screw
for the stainless steel enclosure prevent that the flat ribbon cable is damaged while rotating
the enclosure.
The flat ribbon cable connects the sensor to the electronics.
The tightening torques of the retaining screws are different for the aluminum enclosure and
the stainless steel enclosure. For the tightening torques of the retaining screws, refer to section
Torques (Page 229).
Requirement
You have a 2.5 mm Allen key.
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA
Retaining screw
①
for the aluminum enclosure and two retaining screws (front and back)
Installing/mounting
5.7 Rotating the enclosure
57