Table of Contents
Advertisement
NOTE:
If allowed, by law, in the country in which the
vehicle was purchased, the Daytime Running
Lights can be turned on and off using the
Uconnect System, refer to "Uconnect Settings"
in "Multimedia" for further information.
High/Low Beam Switch
Push the multifunction lever away from you to
switch the headlights to high beam. Pull the
multifunction lever toward you to switch the
headlights back to low beam.
Automatic High Beam — If Equipped
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automating high beam control through
the use of a digital camera mounted to the
windshield. This camera detects vehicle specific
light and automatically switches from high
beams to low beams until the approaching ve-
hicle is out of view.
NOTE:
• The Automatic High Beam Headlamp Control
can be turned on or off by selecting "ON"
under "Auto High Beam" within your
Uconnect settings, as well as turning the
headlight switch to the AUTO position. Refer
to "Uconnect Settings" in "Multimedia" for
further information.
• Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will
cause headlights to remain on longer (closer
42
to the vehicle). Also, dirt, film, and other
obstructions on the windshield or camera
lens will cause the system to function
improperly.
If the windshield is replaced, the camera must
be re-aimed to ensure proper performance. See
a local authorized dealer.
To Activate
1. Turn the headlight switch to the AUTO head-
light position.
2. Push the multifunction lever away from you
(toward front of vehicle) to engage the high
beam mode.
NOTE:
This system will not activate until the vehicle is
at or above 15 mph (24 km/h).
To Deactivate
1. Pull the multifunction lever toward you (or
rearward in vehicle) to manually deactivate
the system (normal operation of low beams).
2. Push back on the multifunction lever to reac-
tivate the system.
The Automatic High Beams can also be deacti-
vated through the Uconnect system. Refer to
"Uconnect Settings" in "Multimedia" for further
information.
Flash-To-Pass
You can signal another vehicle with your head-
lights by lightly pulling the multifunction lever
toward you. This will cause the high beam
headlights to turn on, and remain on, until the
lever is released.
Automatic Headlights
This system automatically turns the headlights
on or off according to ambient light levels. To
turn the system on, rotate the headlight switch
counterclockwise to the AUTO position. When
the system is on, the headlight time delay fea-
ture is also on. This means the headlights will
stay on for up to 90 seconds after you place the
ignition into the OFF position. The headlight time
delay can be programmed 0/30/60/90 seconds.
Refer to "Uconnect Settings" in "Multimedia" for
further information.
To turn the automatic system off, move the
headlight switch out of the AUTO position.
NOTE:
The engine must be running before the head-
lights will come on in the automatic mode.
Parking Lights
Turn the headlight switch knob to the first detent
to turn the parking lights on. This also turns on
all instrument panel lighting.
Headlights On With Wipers
When this feature is active, the headlights will
turn on after the wipers are turned on if the
headlight switch is placed in the AUTO position
and programmable feature is set to on. In addi-
Advertisement
Chapters
Table of Contents
