Valet Mode - Chrysler 300 SRT 2019 Owner's Manual

Shift Light RPM Set-Up
The Shift Light RPM Set-Up allows you to set
the shift light to actuate for gears 1, 2, 3, 4, and
5-8. By pressing and releasing the up/down
arrow buttons on the touchscreen above and
below each listed gear, the RPM values will
change in increments of 250 RPM. Pressing and
holding the arrows will change the RPM values
in increments of 500 RPM, ranging from 2000–
6250 RPM. The Shift Light setup screen may
only be accessed if the feature is enabled. Press
the "Reset to Factory Default" button on the
touchscreen to change back to factory settings,
or press the "Shift Light Off" button on the
touchscreen to turn the system off completely.
266

VALET MODE

Valet Mode Activation
To enter Valet Mode, press the "Valet" button on
the touchscreen and a popup screen will ask
you if you would like to enter Valet Mode. After
selecting "Yes", you will be asked to enter a four
digit PIN code. The PIN code is not set, so you
are free to select any four digit numeric combi-
nation that will be easy to remember.
While in Valet Mode, the following vehicle con-
figurations are set and locked to prevent unau-
thorized modification:
• Engine limited to the lowest power output
state.
• On automatic transmission, transmission
locks out access to first gear and up-shifts
earlier than normal.
• Traction, steering, and suspension are set to
their STREET settings.
• Steering wheel paddle shifters are disabled.
• The Drive Modes interface is not available.
Pressing the SRT button on the touchscreen
will display the unlock keypad.
• The ESC Off button is disabled.
• The Launch Control button is disabled.
Valet Mode Deactivation
To exit Valet Mode, you must enter the same
four digit PIN that was used to enter the mode.
The unlock keypad can be accessed by either
pushing the SRT button on the faceplate, or
pressing the "Valet Mode Active – Press Here to
Exit" button on the touchscreen.