Instrument Cluster Display Controls
Up And Down Arrow Buttons:
Using the up or down arrows allows you to
cycle through the Main Menu Items.
Changes the Main Screen area and Menu Title
area.
Left And Right Arrow Buttons:
Using the left or right arrow button allows you to
cycle through the submenu items of the Main
menu item.
NOTE:
• Holding the up/down or left/right arrow but-
ton will loop the user through the currently
selected menu or options presented on the
screen.
• Main menu and submenu's wrap for continu-
ous scrolling.
70
• Upon returning to a main menu, the last
submenu screen viewed within that main
menu will be displayed.
OK Button:
For Digital Speedometer:
• Pushing the OK button changes units (mph
or km/h).
For Screen Setup:
• OK button allows user to enter menus and
submenus.
• Within each submenu layer, the up and down
arrows will allow the user to select the item of
interest.
• Pushing the OK button makes the selection
and a confirmation screen will appear (return-
ing the user to the 1st page of the submenu).
• Pushing the left arrow button will exit each
submenu layer and return to the main menu.
For the Trip and Fuel Economy menus:
• Information is reset by pushing and holding
the OK button.
NOTE:
Performance Timers can also be reset by push-
ing and holding the OK button. Refer to "Perfor-
mance Pages — If Equipped" in "Multimedia" for
further information.
Engine Oil Life Reset
Oil Change Required
Your vehicle is equipped with an engine oil
change indicator system. The "Oil Change Re-
quired" message will display in the instrument
cluster display for five seconds after a single
chime has sounded, to indicate the next sched-
uled oil change interval. The engine oil change
indicator system is duty cycle based, which
means the engine oil change interval may fluc-
tuate, dependent upon your personal driving
style.
Unless reset, this message will continue to
display each time you place the ignition in the
ON/RUN position. To turn off the message tem-
porarily, push and release the OK or arrow
buttons. To reset the oil change indicator system
(after performing the scheduled maintenance),
refer to the following procedure.
Vehicles Equipped With Keyless Enter-N-Go
— Ignition
Use the steering wheel instrument cluster dis-
play controls for the following procedure(s):
1. Without pressing the brake pedal, push the
ENGINE START/STOP button and place the
ignition in the ON/RUN position (do not start
the engine).
2. Push and release the down arrow button to
scroll downward through the main menu to
"Vehicle Info."