Table of Contents
Advertisement
4 - System setup
Settings
Speed Input Settings
This will show sprayer speed in the upper blue bar of the working screen, when spraying.
ATTENTION!
• The Virtual Terminal has to be setup to "Tractor Alpha speed" or "Radar speed" (Menu 3.1).
• The Display has to be setup to "Broadcast GPS Speed" in the Console Setup ISOBUS Settings menu.
Choices for Primary Source include:
• Hardi
• Display GPS
• Auxiliary Device
Other Possible Options (not used for HARDI®
sprayers):
• Manual Speed
Primary Source selections to use:
Hardi
Trailer sprayer with
Must always use "Hardi" as
SafeTrack/IntelliTrack
speed source as the steering
system cannot use GPS as
speed source.
Self-Propelled sprayer
Can be used.
SARITOR sprayer
Not used.
Lift mounted sprayer
Not used.
*Choices for Auxiliary Device Channel include:
• Wheels
• Radar
If you are using a backup radar speed source it is recommended that you calibrate it before the season begins.
• Filtered
This setting is used only as a backup speed source for low pulse ground speed sensors.
ATTENTION! When "Hardi" option is selected as Primary Source, you may use the VT speed calibration (menu 3.1).
÷
NOTE! If "Display GPS" is selected, the "Hardi" option must be selected as backup source.
4.70
Your Specific
Configuration
Configuration
Display GPS
Auxiliary Device
Not used.
Not used.
Can be used.
Not used.
Always select "Display GPS" as
Not used.
speed source.
Can be used.
Can use speed input from the
tractor*
Speed Input
Speed Input
Primary Source
Hardi
Manual Speed
Not used.
Not used.
Not used.
Not used.
Speed
Input
Advertisement
Table of Contents
