Table of Contents
Advertisement
2. Flip the PHM over to align
the carrier with the
bolster plate.
3. Flip the PHM over, so the package
land of the processor will face the
socket. Lower the PHM vertically to
engage it to the alignment pins of
the bolster plate.
4. Make sure the PHM is sitting
horizontally on the bolster plate.
5. Use a torque driver to tighten the
four nuts to 12 in-lbf into the bolster
plate
following
the
indicated on the heat sink (#1
#2#3#4).
PIN1
of
Cutout
of the
sequence
Chapter 2: Hardware Installation
Cutout
Alignment Pin
3
4
5
28
2
Alignment Pin
Advertisement
Table of Contents
