Power Source - Lanner NCA-5710 User Manual

NCA-5710 User Manual
Follow the instructions below to connect the DC power cord to the connector on the PSU. This instruction is
for the installation of the conductor to build earthing by a skilled person.
1. Loosen the + and - screws.
2. Respectively attach the two cables to the connectors: the red cable to the right (Positive Pole) and the
black cable to the left (Negative Pole).
3. Fasten the screws.
4. Connect the power cables to the power source.
This product is intended to be supplied by a UL Listed DC power source, rated -48- -60Vdc, 21A
minimum, Tma = 40 degrees C, and the altitude of operation = 5000m.
The cable should be 12AWG (21A minimum, 60V minimum).
If you need further assistance with purchasing the power source, please contact to Lanner Electronics Inc.
for further information.
+
一

Power Source

45