Lanner NCA-5710 User Manual page 128

NCA-5710 User Manual
1. In the command window, execute this utility with the following command:
hot_swap.sh
2. Input the power-off command to disconnect the power supply of the target PCIe slot.
hot_swap.sh 1 off
[Slot No.][Command]
The slot names map to the physical slots as shown below:
3. After the confirmation message of disconnection is returned, remove the target PCIe module from its
slot.
4. Insert the new PCIe module into the slot and secure the slot cover.
5. Input the power-on command to power-on f the target PCIe slot.
hot_swap.sh 1 on
[Slot No.][Command]
6. After the confirmation message of connection is returned, the physical link is established and the new
PCIe module should already be in service.
Note
Only one module can be removed at a time.
1 2
(Slot 1) (Slot 2)
Connection status: OFF
Connection status: ON
128
3 4
(Slot 3) (Slot 4)
Power-off command
Power-on command