Avaya IG550 Quick Start Manual page 18

At the TGM550-00<super># prompt, type show boot bank to
●
determine the non-active disk partition (bank). You copy the firmware to
the non-active boot bank.
At the TGM550-00<super># prompt, type one of the following
●
commands, depending on whether the file resides on an FTP, or TFTP
server:
- copy [tftp or ftp] SW_image <bank> <filename>
<server_ip_address>
where <bank> is the bank that is the non-active boot bank,
<filename> is the full path name of the firmware image file, which
begins and will be similar to the name tgm550_sw_26_26_0.bin,
and <server_ip_address> is the IP address of the FTP or TFTP
server.
For an FTP server, enter the login and password, if prompted.
●
Logout of the tftp or ftp server.
●
At the TGM550 command line, enter show download software
●
status 10 and check the status of the download.
At the TGM550 command line, type set boot bank bank-<bank>
●
where <bank> is the same letter you entered in the previous step.
Enter copy running-config start-config.
●
Type exit to return to the Juniper Services Router CLI.
●
Enter request chassis fpc restart slot <slot_number> to
●
reset the TGM550
where <slot_number> is the slot of the TGM550.
Log in to the TGM550 again.
●
At the TGM550-00<super># prompt, type show mg list_config.
●
Verify the system the list of software.
●
6. Check the authentication file ID (Avaya personnel only).
At the TGM550 command line prompt, type show auth-file info.
●
In the AF ID field, record the 10-digit AF ID, for example,
●
7. Register the password (authentication) file with the ART tool (Avaya
personnel only) or with the appropriate customer care center (business
partners only).
18 Quick Start for Hardware Installation: IG550 Integrated Gateway
.
7000003638