Avaya IG550 Quick Start Manual page 16

● set system login user <user_name> class super-user
where <user_name> is the user login to the router from TGM550. This
command is completed based on customer requirements.
Complete the password prompts.
● set system login user <user_name> authentication
plain-text-password.
At the two password prompts, enter the password.
!
CAUTION:
If a root password has not been set, you must set a new
CAUTION:
password before you commit the configuration. Check with your
Project Manager to get the password.
8. At the prompt, type commit
The system may take some time to commit the commands and reset.
9. Configure the MGC list.
a. At the configure prompt (
b. At the cli prompt (>), enter set tgm fpc <slot_number>
media-gateway-controller [<IP_address1>
<IP_address2> <IP_address3> <IP_address4>]
where <slot_number> is the location of the TGM550,
<IP_address1> is either the Processor Ethernet IP address of the
primary server (S8300, S8400, or S8500) or an IP address to a C-LAN
connected to the primary server (S8400, S8500, or S8700-series). The
additional IP addresses are the addresses for additional C-LANs or
Local Survivable Processors (S8300 or S8500).
10. Set the WAN interface. See Juniper J-Series Services Router Getting
Started Guide. See J-Series Services Router Basic LAN and WAN Access
Configuration Guide.
11. Set routing options using static routes, OSPF, RIP, BGP, or IS-IS
protocols. See J-Series Services Router Basic LAN and WAN Access
Configuration Guide.
12. Connect the USB modem to one of the USB ports.
13. Configure the USB modem. See Installing and Configuring the IG550
Integrated Gateway, 03-601548.
16 Quick Start for Hardware Installation: IG550 Integrated Gateway
.
), enter exit
# .