Suzuki SY413 Service Manual page 3099

6E1-66 ELECTRONIC FUEL INJECTION SYSTEM (G13/G16 ENGINE WITHOUT WU TWC)
TERMINAL CIRCUIT
C7 C7 TP sensor TP sensor
C8 MAP sensor
VSS ()) (3 A/T only)
C9
VSS (M/T and 4 A/T only)
CKP sensor ())
(without immobilizer)
C10 C10
CMP sensor
(with immobilizer)
CKP sensor ())
(with immobilizer)
C11 C11
CMP sensor
(without immobilizer)
C12 Ground
C13 "L" range signal (3 A/T only)
C13 L range signal (3 A/T only)
"D" range signal (3 A/T only) D range signal (3 A/T only)
C14 C14
Transmission range signal
from TCM (4 A/T only)
C15 C15 "R" range signal (3 A/T only) R range signal (3 A/T only)
Power steering pressure
C16
switch
C17 Sensor ground
C18 IAT sensor
Heated oxygen sensor
C19
(HO2S) (if equipped)
C20 VSS (–) (3 A/T only)
CKP sensor (–)
(without immobilizer)
C21
Blank (with immobilizer)
CKP sensor (–)
(with immobilizer)
C22
Blank (without immobilizer)
NORMAL VOLTAGE
3.27 – 4.58V
0.18 – 1.03V
3.3 – 4.0V
0.4 – 0.8V
Indicator deflection
repeated
0 – 1V and 4 – 6V
0.4 – 0.8V
0 – 0.8V
0.4 – 0.8V
0 – 0.8V
About 0V
10 – 14V
0 – 0.5V
10 – 14V
0 – 0.5V
0 – 1.5V
g g
10 – 14V
10 – 14V
0 – 0.5V
10 – 14V
0 – 1.5V
About 0V
4 – 5V
Indicator deflection
repeated between
over and under
0.45V
0.4 – 0.8V
0.4 – 0.8V
—
0.4 – 0.8V
—
CONDITION
Ignition switch ON
Throttle valve at idle position
Ignition switch ON
Throttle valve at full open position
Ignition switch ON
Ignition switch ON
Ignition switch ON
Front left tire turned quickly with front right tire locked.
Ignition switch ON
Ignition switch ON
Ignition switch ON
Ignition switch ON
—
Ignition switch ON
Selector lever at "L" range
Ignition switch ON
Selector lever at other than "L" range
Ignition switch ON
Selector lever at "D" range
Ignition switch ON
Selector lever at other than "D" range
Ignition switch ON
Selector lever at "R", "D", "2" or "L" range
Ignition switch ON
Selector lever at other than "P" or "N" range
Ignition switch ON
Selector lever at "R" range
Ignition switch ON
Selector lever at other than "R" range
Ignition switch ON
With engine running at idle speed, turning steering wheel
to the right and left as far as it stops, repeating it a few
times
—
Ignition switch ON
When disconnecting IAT coupler
When engine running at 2000 rpm for 1 minute or
longer after warmed up
Ignition switch ON
Ignition switch ON
—
Ignition switch ON
—