Suzuki SY413 Service Manual page 3111

6E1-78 ELECTRONIC FUEL INJECTION SYSTEM (G13/G16 ENGINE WITHOUT WU TWC)
9) Remove special tools from fuel delivery pipe.
10) Connect fuel feed hose to fuel delivery pipe and clamp it se-
curely.
11) With engine "OFF" and ignition switch "ON", check for fuel
leaks.
FUEL PUMP
ON-VEHICLE INSPECTION
CAUTION:
When fuel filler cap is removed in any procedure, work
must be done in a well-ventilated area, keep away from
any open flames and without smoking.
1) Remove fuel pump controller, referring to "FUEL PUMP CON-
TROLLER (4WD VEHICLE ONLY)" in this section.
2) Remove filler cap and turn ON ignition switch. Then fuel pump
operating sound should be heard from fuel filler for about 2 se-
conds and stop. Be sure to reinstall fuel filler cap after checking.
If above check result is not satisfactory, advance to "DIAGNOS-
TIC FLOW TABLE B-1".
3) Install fuel pump controller, referring to "FUEL PUMP CON-
TROLLER (4WD VEHICLE ONLY)" in this section.
1. Fuel filler
2. Ignition switch
4) Fuel pressure should be felt at fuel return hose for 2 seconds
after ignition switch ON.
If fuel pressure is not felt, advance to "DIAGNOSTIC FLOW
TABLE B-3" in this section.
REMOVAL
1) Remove fuel tank from body according to procedure described
in Section 6C and remove fuel pump from fuel tank.
INSPECTION
Check fuel pump filter for evidence of dirt and contamination. If
present, clean and check for presence of dirt in fuel tank.