Suzuki SY413 Service Manual page 3308

6G1-8 CRANKING SYSTEM
1. Over-running clutch
2. Pinion stop ring
3. Snap ring
4. Planetary carrier shaft
A: Locator for plate
B: Locator for drive housing
5) Remove snap ring, then pull out pinion stop ring and overrun-
6) Using special tool, remove circlip, then take out planetary carri-
1. Center bearing & shock
absorber
2. Circlip
3. Planetary carrier shaft
7) Remove internal gear from bearing & shock absorber.
1. Internal gear
2. Bearing & shock
absorber
3. Clutch plate
A: Align locators
8) Remove rear bracket.
C: Align mark
9) Remove armature from yoke.
1. Yoke
2. Armature
ning clutch assembly.
Special Tool
(A): 09900-06107
er shaft from center bearing & shock absorber.
Special Tool
(A): 09900-06107
NOTE:
When removing internal gear from bearing & shock ab-
sorber, make sure locators are aligned each other.