Henny Penny Evolution Elite EEG-16 Series Technical Manual page 62

Attach wheel puller to OD of wheel hub by tighten 3 hex head bolts down with 1/
2 2 ) )
2" wrench, making sure to keep the puller centered along the wheel/shaft axis.
Turn screw to remove the wheel from the motor shaft.
3 3 ) )
With wheel removed apply degreaser and wash wheel in dishwasher or sink to
4 4 ) )
remove dirt and grease. Use of a soft bristle brush is permissible.
File down the burr on the shaft left by the set screw, to allow wheel to slide onto
5 5 ) )
shaft freely.
Install wheel with hub set to end of shaft and tighten set screw.
6 6 ) )
50