Henny Penny Evolution Elite EEG-16 Series Technical Manual page 49

Unplug the connectors going to the control board (1).
5 5 ) )
Install a new control panel in reverse order.
6 6 ) )
6 6 . . 5 5 H H i i g g h h T T e e m m p p e e r r a a t t u u r r e e L L i i m m i i t t C C o o n n t t r r o o l l
Remove electrical power supplied to the unit.
1 1 ) )
W W A A R R N N I I N N G G ! ! S S H H O O C C K K H H A A Z Z A A R R D D T T o o a a v v o o i i d d e e l l e e c c t t r r i i c c a a l l s s h h o o c c k k o o r r p p r r o o p p e e r r t t y y d d a a m m a a g g e e , ,
m m o o v v e e t t h h e e p p o o w w e e r r s s w w i i t t c c h h t t o o O O F F F F a a n n d d d d i i s s c c o o n n n n e e c c t t m m a a i i n n c c i i r r c c u u i i t t b b r r e e a a k k e e r r , , o o r r u u n n p p l l u u g g
c c o o r r d d a a t t w w a a l l l l r r e e c c e e p p t t a a c c l l e e . .
Lower the control board (refer to the Control Board section).
2 2 ) )
Remove the heat shield which covers the high limit control.
3 3 ) )
Mark and disconnect the wires located on the high limit control.
4 4 ) )
37