Henny Penny Evolution Elite EEG-16 Series Technical Manual page 43

DTx = tank full
5 5 . . 4 4 . . 1 1 1 1 T T - - 2 2 1 1 - - P P u u m m p p s s & & V V a a l l v v e e s s
Press the down arrow and "LIGHTS" "DLT_" shows in displays.
1 1 ) )
Press product button 1 and left Filter Beacon lights (split vats) and press product
2 2 ) )
button 2 and right Filter Beacon lights (display shows "DLTo" when on).
Press the down arrow and "VALVES" "DcRc" shows in displays.
3 3 ) )
Press product button 7 to open and close the return valve.
4 4 ) )
"DcRc" means valve is closed, "DcRo" means valve is open (Driven by the
5 5 ) )
control board).
Press the down arrow and "DISCARDc" and "JIBFILLc" shows in the displays
6 6 ) )
(Driven by the AIF board).
Press product button 1 to open and close the RTI discard valve (display shows
7 7 ) )
"DISCARDo" when open).
Press product button 2 to open and close the RTI JIB fill valve (display shows
8 8 ) )
"JIBFILLo" when open).
Press the down arrow and "PUMP FP_" and "JP_ NP_" shows in the displays
9 9 ) )
(Driven by the AIF board).
Press product button 1 to turn off and on the filter pump (display shows "FP*"
1 1 0 0 ) )
when on).
Press product button 2 to turn off and on the JIB pump (display shows "JP*"
1 1 1 1 ) )
when on).
Press product button 3 to turn off and on the new oil pump (if available - display
1 1 2 2 ) )
shows "NP*" when on).
Press the down arrow and "AIF REQ" and "RQ=Y OK=Y" shows in the displays.
1 1 3 3 ) )
REQ=Y" means that this particular control is currently requesting control of the
AIF Board outputs. "OK=Y" means that the AIF Board has granted this control
the authority to control the AIF Board outputs.
Press the down arrow and "FILR IN" and "USE BY 1(ex)" shows in the displays.
1 1 4 4 ) )
These displays shows which controls are using the filtering system.
"USE = 0" = not in use
"USE = 7" = used by AIF
"USE = 1 to 5" = used by control PCB
Press the down arrow and "CPU POSN" and "1 OF 3(ex)" shows in the displays.
1 1 5 5 ) )
These displays shows which controls are plugged into which port on the AIF
board. For example, the left control should be plugged into port 1, and on a 3
control fryer, shows "1 OF 3" on the display. If the right control is unplugged,
then the left control would show "1 OF 2" instead of "1 OF 3".
Press the down arrow and "INP E_P_" and "JL_Rx DF_" shows in the displays.
1 1 6 6 ) )
Press the down arrow and "OUT F_J_" and "N_DI_oJF_" shows in the displays.
1 1 7 7 ) )
Press the down arrow and "REQ F_J_" and "N_DI_JF_" shows in the displays.
1 1 8 8 ) )
AIF Board Outputs Requested by the Control Board:
Current outputs status from AIF board.
31